Simplex 4004 Instruction Manual download pdf (Page 13)

3-1

IMPORTANT: Notify appropriate personnel (building occupants,

fire department, or monitoring facility, etc.) of the

installation. Before beginning installation, ensure that

you are thoroughly familiar with these instructions and

all applicable regulatory requirements. (Refer to

Chapter 2 - Requirements and Accessories.)

The following tools and equipment are required for 4004 installation:

• 1/4-inch Flat-Tip Screwdriver

• Volt-Ohmmeter

• Diagonal Cutting Pliers

• Wire Strippers

• End-of-Line Resistors (supplied by Simplex)

• The 841-992 Field Wiring Diagram

The installer is responsible for safeguarding all 4004 material shipped to the job

site. During system installation, store all 4004 items (including all

documentation) in a clean, dry, and safe place until needed.

1. Remove the back box from the shipping container and lay it on a flat

surface.

2. Using the information in Figure 2 as a reference, install the back box.

• For specific internal wiring directions, refer to Figure 2 and the

841-992 Field Wiring Diagram.

Continued on next page

Chapter 3

Installation

Requirements

Back Box

Technical Manuals Online! - http://www.tech-man.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Simplex 4004 Instruction Manual Page 13