Simplex 4100ES-S1 Specifications download pdf (Page 102)

8-1

{xe "service port"}

The 4100ES-S1 is tested in the factory and is loaded with a basic configuration.

When the panel arrives on site the installer must unpack and check the panel, mount the

cabinet, any additional cards, and check the configuration before applying power.

A registered electrician must connect the mains. The panel should then be powered up

and checked for correct operation.

With the mains turned off and the batteries disconnected, the field wiring is checked and

connected to the field terminals on the various cards.

The panel should then be powered up and re-programmed to accommodate all the

connected field devices. Faults in the field wiring, misaddressed detectors / devices and

mismatched detectors / devices will be displayed on the LCD. These should be cleared

one at a time and then the system (panel plus connected devices) should be

commissioned.

Refer to the page number listed in this table for information on a specific topic.

Topic See Page #

Alignment & Adjustment 8-2

Power Up & Placing into Operation 8-3

Maintenance 8-4

Chapter 8

Installation Checklist, Commissioning & Maintenance

Introduction

In this Chapter

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 172 173

No comments

Simplex 4100ES-S1 Specifications Page 102