Simplex 4100ES-S1 Installation Guide download pdf (Page 15)

4100/4120

Programming

The DACT must be selected in the Programmer. Refer to Serial DACT Installation and Program-

ming Instructions (574-090) for specific programming requirements.

4100U/4100ES

Programming

The correct DACT card must be selected in the 4100U/ES Panel Programmer. Refer to the

ES Panel Programmer’s Manual (574-849).

Additional

Programming

When a DACT connects to a TL300, additional programming is required.

1. To monitor the relay contact of a relay located in the cabinet with the TL300. This relay will

energize and open the IDC circuit when the Ethernet connection to the Central station has been

broken.

2. Program a Relay so that it will energize on the telephone Line 1 or Line 2 fault. The N.O.

contacts will connect to GND and AN4 of the TL300.

An example equation is below. The Serial DACT is at address 9 and the Aux relay on the SPS

(Aux 3) is used.

INPUTS]

STATUS TBL

9-0-3 | CARDSTAT | CSP | PHONE LINE 1

OR STATUS TBL

9-0-4 | CARDSTAT | CSP | PHONE LINE 2

[END INPUTS]

[OUTPUTS]

TRACK ON PRI=9,9

AUX3 | RELAY | RELAY | AUX RELAY CARD 1 RELAY CKT AUX3

[END OUTPUTS]

TL300

Programming

Refer to T-Link TL250/TL300 Network Internet Alarm Communicator #29034631 for informa-

tion concerning the programming of the TL300.

In addition to the required programming in the manual for the ULC compliance:

•

Section 035 PGM1 needs to be Enabled.

•

Section 039 needs to be code 98 24 hr. Panel Absent.

Programming

1 2 ... 10 11 12 13 14 15 16 17 18

No comments

Simplex 4100ES-S1 Installation Guide Page 15