© 2005-2011 SimplexGrinnell LP. All rights reserved.Specifications and other information shown were current as of publication and are subject to chang
10Wiring GuidelinesReview the following guidelines before wiring P1 and P4 of the DACT.•If U.T. motherboard 565-274 or 565-213 is wired to the DACT, j
11Wiring the DACT to the TL300Wire the DACT to the TL300 in accordance with Figure 6 and Figure 7.Figure 6. Wiring the DACT to the TL300#18-22 awg 150
12Wiring the DACT to the C900V2 DACT (UL only)Figure 7. Wiring the DACT to the C900V2 DACT (UL only)(2/5&9%RVFK $( HQFORVXUH DZJP
13OverviewBoth assemblies are designed for different systems.•The 4100/4120-0155 Serial DACT mounts into a non-4100U/4100ES systems (with 2975-91xx Ba
14 Mounting DACT 4100-6052 •The 4100-6052 DACT can only be installed in the CPU bay.•The DACT must be the leftmost assembly in the CPU bay.•See Figure
154100/4120 ProgrammingThe DACT must be selected in the Programmer. Refer to Serial DACT Installation and Program-ming Instructions (574-090) for spec
16TestingWhen the DACT is connected to the system, its operations should be tested with the manual TEST switch (SW1). The manual test ensures that: •T
17Compatibility Refer to Table 4 for compatibility information.Table notes:1. 10 and 20 PPS (Pulses Per Second)2. With 685-8 Line Card3. With 9032 Lin
574-836Rev. N
2Cautions and WarningsREAD AND SAVE THESE INSTRUCTIONS. Follow the instructions in this installation manual. These instructions must be followed to av
3OverviewDigital Alarm Communications Transmitter’s (DACT) are option cards that mount within 4100 Fire Alarm Control Panels (FACP).The 4100/4120-0155
4C900V2 Ethernet Transmission (UL only)The DACT receives system status messages from the 4100U/4100ES using the codes listed on page 17. It then commu
5 LEDsRefer to Table 1 for DACT LED indicators. SpecificationsRefer to Table 2 for DACT electrical requirements and environmental limitations.Table 1.
6Power-limited Wiring Guidelines•Non-power limited field wiring (AC power, batteries, City connection) must be installed and routed in the shaded area
7Before InstallationHave the telephone company install two telephone lines, each terminated with an RJ-31X jack immediately above or as close as possi
8OverviewConfiguring the DACT consists of:•Setting the correct communication mode•Specifying whether the DACT is in Test mode•Specifying whether the D
9Setting the addressTable 3. DACT card switch settings $GGUHVV 6: 6: 6: 6: 6: 6: 6: $GGUHVV 6: 6: 6:
Comments to this Manuals