Simplex 4100ES-S1 Operator's Manual download pdf (Page 13)

1-3

The Simplex 4100ES-S1 Fire Indicator Panel (FIP) has three general functions.

 It monitors fire alarm initiating points (smoke detectors, heat detectors, etc.).

 It activates fire alarm notification devices (bells, strobes, brigade call) when an initiating

point activates.

 It monitors and controls ancillary building equipment (fan controls, relays, etc.).

Note: The term point is used extensively throughout this manual. It is a generic term used

to refer to an individual component of the system, such as a single smoke detector, a

single break-glass manual call point, etc.

The operator interface, shown in Figure 1-2 and described in Table 1-1, allows a system

operator to control and monitor the site-specific components connected to the 4100ES-S1.

Figure 1-2. Operator Interface

Table 1-1. Components of the Operator Interface

LED/KEY

Description

Refer To

Zone Alarm LED

This LED flashes when any Zone

Alarm LED is on and the zone is not

isolated. It goes steady when all

zones in alarm are isolated.

Control Keys

Typical functions include: Alarm Test,

Fault Test, Bell Isolate, Warning

System Isolate & ACF Isolate.

Chapter 1

ALARMS

Fire Alarm LED

The Fire Alarm LED flashes to

indicate the presence of an

unacknowledged alarm condition.

Other components of the system,

such as the horns and strobes, also

activate to indicate the presence of

an alarm.

Chapter 2

Fire Alarm Ack Key

The Fire Alarm Ack key allows you to

indicate that you have observed the

presence of an alarm.

Chapter 2

Priority 2 Alarm LED and

Ack Key

Not normally used in Australia.

N/A

Continued on next page

Basic System Description

Overview

Control Keys

& Indicators

Function/

Numeric

Keypad

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Comments to this Manuals

No comments

Simplex 4100ES-S1 Operator's Manual Page 13

Comments to this Manuals

Related products and manuals for Fire protection Simplex 4100ES-S1